Edit Data Store

To edit a data store:

  1. Go to your Control Panel's Settings menu.
  2. Click the Data Stores icon. You'll see a list of the data stores on your system.
  3. Click the Actions button next to the store you want to change, then click Edit.
  4. On the following page the appropriate data store details:
    • Label - the name of the data store.
    • IP address - the IP address of the data store.
    • Iscsi IP - iSCSI IP address.
    • Disk Capacity - set disk capacity in GB.
    • Enabled - move the slider to the right to enable a data store. When disabled, OnApp will not allow new disks to be created automatically on that data store. This is useful to prevent an established data store from becoming too full. It also lets you prevent the automatic creation of root disks on 'special' data stores (high speed, etc).
    • Local Compute resource - if required, you can also bind the data store with a local Compute resource. This is helpful if you wish that the data store and a Compute resource were located on the same physical server thus decreasing the time needed for a Compute resource-data store connection.
    • Data Store Zone - if required, you can also assign the data store to a data store zone. The drop-down menu lists all data store zones set up in the cloud (to add or edit data store zones, see Data Store Zones Settings).
    • Data store type - choose the data store type.
  5. Click the Save Data Store button to finish.